欲妇放荡叫床很浪

<cite id="acvxh"></cite>

<sub id="acvxh"><sup id="acvxh"></sup></sub>
  • <ol id="acvxh"></ol>

  • <strong id="acvxh"></strong>

    <span id="acvxh"><sup id="acvxh"></sup></span>

    <acronym id="acvxh"></acronym>
  • Shenzhen Paike Automation Equipment Co., Ltd.

    0755-29187616 18503006781
    HomeNews> Technical information

    Paike Automation will "reveal" for you to solve the problem of baler failure

    source: Shenzhen Paike Automation Equipment Co., Ltd. popularity:125 Time of publication:2020/08/17 18:56:43 small middle bog

      Solving the problem of packing machine failure is very important for partners in the packaging industry, so Paike Automation will now reveal some methods to solve the problem of packing machine failure. I hope it will be helpful to everyone.


      The reasons for the bad bonding effect of the packer:


      1. It may be because the temperature of the pp belt of the baler is too high or not enough. If you use a special belt, the viscosity is poor, and a very accurate temperature must be required.


      2. On the one hand, the voltage of the packaging machine may not be enough. At this time, you can choose to use it and you must use an extension cord. You need to connect a thicker but not too long wire.


      3. It may be that the 635 bearing under the middle knife of the semi-automatic baler is broken, which will cause heating and completely unable to bond.


      4. The long tension spring on the electric heating pendulum bar of the automatic baler is damaged, and it will cause bad adhesion due to the inability to pull the monster to the position.


      5. The position of the electric steel sheet of the baling strapping machine is not accurate. It is too high or too low or too left or right. Too high or too low will hit the top and bottom strapping pp belt, and the left and right will hit the left and right tools, so As a result, the heating cannot be entered, which should be adjusted according to the specific situation.


      6. If the micro-fan used to exhaust smoke of the carton packer fails, it will also cause the temperature to be too high, which will affect the effect of packaging and bonding.
      

      was cut off without tightening:


      1. The tightness of the baler is adjusted too much, just tighten it.


      2. The position of ls3 and ls5 of the packer is not suitable.


      3. The failure of the magnetic induction switch of the strapping machine.


      The reason why the packer keeps sending tape:


      1. If the potentiometer of the strapping machine is faulty, just replace it.


      2. The button of the strapping machine has a green button or other failures, just replace the button.
    欲妇放荡叫床很浪
    <cite id="acvxh"></cite>

    <sub id="acvxh"><sup id="acvxh"></sup></sub>
  • <ol id="acvxh"></ol>

  • <strong id="acvxh"></strong>

    <span id="acvxh"><sup id="acvxh"></sup></span>

    <acronym id="acvxh"></acronym>